April 20, 2021

Design patterns on pots

The Half Call design pattern is described using a standard pattern definition template.

Intent

The actions involved in a call processing can be categorized in two half calls. One half of the call handles the signaling involved in the originating end of the call. Other half call component handles the signaling involved in the terminating end of the call. This partitioning of a call in half call components simplifies the call design. Consider that a switch were to support N signaling systems. If half call design pattern is not used, it would have to deal with N x N call types to support all the signaling interworking call scenarios. With half call design pattern, each signaling type maps to originating and terminating half calls. Thus the number of call types to be supported is reduced to 2 x N.

Also Known As

End Call Design Pattern
End Point Protocol Design Pattern

Motivation

Consider the case where a switch has to support the following signaling schemes:

SS7 ISUP (ISDN User Part)
R2 Signaling
POTS (Plain Old Telephone Service) Subscriber
V5.2 Subscriber

If half call was not supported, the switch will have to support the following call types:

ISUP to R2 Call
R2 to ISUP Call
ISUP to POTS Call
POTS to ISUP Call
POTS to R2 Call
R2 to POTS Call
ISUP to V5.2 Call
V5.2 to ISUP Call
R2 to V5.2 Call
V5.2 to R2 Call
POTS to V5.2 Call
V5.2 to POTS Call
ISUP to ISUP Call
R2 to R2 Call
POTS to POTS Call
V5.2 to V5.2 Call

With half call design pattern, the switch will have to support only the following call types:

ISUP Originating Call
ISUP Terminating Call
R2 Originating Call
R2 Terminating Call
POTS Originating Call
POTS Terminating Call
V5.2 Originating Call
V5.2 Terminating Call

Thus there is a major simplification in the design when half call design pattern is used.

Applicability

This design pattern can be applied whenever a system needs to support interworking between different types of protocols. If the design models the interactions between originating and terminating end points as a single entity, the interworking design would be complicated by the large number of entity types. Also, the design would scale very poorly when new protocol type needs to be supported. In such cases, apply the half call design pattern. The originating and the terminating protocol end points should be modeled as separate entities (half calls).

Structure

Instead of having a N x N mesh of protocol end point interactions, this design pattern implements the system with 2 x N end points. For this design pattern to work, a standard protocol should be defined between a typical originating and terminating end point protocol.

Participants

The originating and terminating protocol end points are the main actors in this design pattern. In some scenarios, an intermediate broker object may have to be designed to coordinate the interactions between originating and terminating end points.

Collaboration

The originating and terminating end point protocols use a standard protocol to communicate with each other. The originating and terminating ends are not aware of the type of the other end of the protocol.